T-Rex 600N (belt version) last updated 7-4-2007

Page 6a[click here for index]

Next from the bag 600NH remove the sub bag 600NH3. It has the flybar seesaw holder that will go on the head block. Make sure that the bearings are already installed in this part. There are four total. And notice the position of the 90 degree corners and the slanted corners in the picture above. It is easy to get this mixed up. Raise the seesaw holder all the way up then rotate it 90 degrees and lower it to the middle section.
Now that you have the holder in place use the two M3 collar bolts to attach the holder to the head block. Use blue loctite on these bolts.

Go to Page 2