Raptor 30/50 v1 assembly manual
Page 13 [click here for index]

The landing gear set is designed to be installed with the struts angled forward. Some people however install it backwards to get the tail a little higher off the ground. This helps if you take off and land in tall grass or on uneven ground, but it does cause the canopy clip not to fit well, the protective antenna tube guides to be on the wrong side, and it looks a little funny.
Start by bolting the front and back struts (2) to the frameset using four (1) screws. next slide each skid (4) into the struts. Adjust the skids so that there is 30mm from the back of the skid to the back of the rear strut then secure them with set screws (2). Don't used loctite, you are going into plastic. Later as the bottom of the struts wear down from landing on pavement then check out the tips on <this page>

Go to Page 14