Raptor 30/50 v2 assembly manual
Page 9 [click here for index]

At this point you should have the pitch arm installed as well as the elevator control lever that is in between the two loops at the back of the pitch arm. Start on the left side of the helicopter and insert the bearing (6) into the loop at the back of the pitch arm. Then insert the grey shaft (16) followed by the screw (1). Now on the right side of the helicopter insert the bearing (6) into the rear loop of the pitch arm. Next insert the lever (18), make sure the elevator control lever (page 9 item 15) is level and the lever (18) is 90 degrees to it (and pointed down). Use the screw (1) to secure the lever in place.
Next slide the ball (13) on the screw (5) and install into Aileron Control Lever (17). As usual make sure the silver screw is just tight enough that the ball will not rotate freely on the screw. Use another screw (5) and ball (13) and install on the left side of lever. Install the two bearings (7). Slide the sleeve (9) onto the screw (1) and insert through the bearings of the lever (17). Add a small drop of CA to the tip of the screw and install into the pitch arm. Do the same for the left side, but make the ball (13) on the right side (facing toward the pitch arm).
Next make up a link using a BK0093 rod and two BK0086 links. From each center of hole, it needs to be 66mm. Make sure the labels are facing out, and snap in place on the lever (21) and the inside ball of the lever (21).

For 29BB kits, model numbers 4831/4832,
(7) will be replaced by Bushing(BK0107x6)
(8) will be replaced by Bushing(BK0108x2)

v1/v2 differences - All the parts are the same but the pitch that comes with the v2 has a new stronger design like used on the Raptor 60. The part number for the new pitch arm is the same so as stock of the old part is depleted all further orders will give the new design pitch arm. The new and old pitch arms are interchangable. You can put a new pitch arm on a v1 or even put an old pitch arm on a v2.

Go to Page 10