Raptor 30/50 v2 assembly manual
Page 25 [click here for index]

This is the end of my manual, there is not much left to finish the assembly. You can refer to the original manual on page 15, step 18, to install the main blades. Make sure you glue the blade grips as described in the addendum (or on the ACE website). Also that you install them in the right direction. An easy way to tell is to look at the screws in the blade grip, the head of the screws should be facing upward. Also the leading edge (the thicker part) should be in front as viewed from a clockwise rotation). Also the heat shrink covering on the wood blades need to be re-shrunk. Use a hair dryer if you don't have a heat gun and if you have neither you can use steam from boiling water to shrink the covering. Try to evenly go over the whole length of the blade, if you stay just in one spot you might split the covering on the ends.
Step 19: The manual has you mounting the receiver with double-sided tape, this is rediculous! Believe me, the receiver would much appreciate it if you mount it with some automotive weatherstrip tape. I have details on Step 17 on the ARF construction page. And if you are going to do 3D flying then I highly suggest you add a bolt to secure the canopy clip. Details of this are on <this page>.
For the radio setup, go to my radio setup page.