T-Rex 600N (belt version) last updated 7-4-2007

Page 6b[click here for index]

Open the bag 600NH3A into your container. NOTE: When installing the mixing arms on the flybar carrier, notice that two of the balls are short and two are long. Install the long ones on the long side of the mixing arm and the short ones on the short side. See the picture above.

Next slide a 3mm x 4.8m washer on the T3x14mm button head bolt. Install this through the mixing arm. Note the head of the bolt will be on the opposite side of the link balls as you can see in the drawing. Slide another washer on then install the assembly onto the flybar seesaw holder. There are two holes to chose from I recommend using the outside hole.

Go to Page 2