T-Rex 600N (belt version) last updated 7-12-2007

Page 9b[click here for index]

Now take the clutch bell assembly out of bag 600NB4A. Dump the bolts from bag 600NB4B into the parts bowl. In the kit I built the clutch liner was already glued in but do check it. The bell was already on the pinion gear and the bearing and was secured with the special nut. All that was left to do was slide the start shaft in place, slide the bearing 5x13x4mm bearing on and then attach the start coupler using two M4 set screws. Use blue loctite on these set screws and not that they should fit into the indentations in the start shaft.

Next set the clutch assembly inside one half of the bearing block. The top and bottom bearings fit in track on this block. Slide in a couple of the 5x49mm hex mounting bolts then put the other half of the bearing block on. Secure the two halves together using two M3x8mm bolts and two M3 nuts. Note that the hex shaped hole in the bearing block is for the nut and the round one is for the bolt.

Go to Page 2