T-Rex 600N (belt version) last updated 7-12-2007

Page 10a[click here for index]

Note: If you have a governor/limiter then you need to mount the sensor now. It is much easier to add it now then later after the frame is already put together. It will use the two holes just under the frame plate bearing that is circled red in the picture below.

Now for the frame assembly, open bag 600NB
Start by bolting everything to the right frame plate. Notice the bearing that is circled in red, The bearing is inserted from what is concidered the inside of the frameset so this is how you can tell what is the left frame plate and which is the right. Do not tighten any of the bearing block bolts yet. Just get them snug because later when the left frame plate is added we will need to square up the frame before adding loctite to the bolts and tighten them.
Bolt the clutch bell bearing block to the frame. Use the allen bolts with the flat heads. Make sure you align the sholder just under the head with the holes in the frame. If you look at the second picture you can see the heads of the bolts.
Open bag 600NB1 sub bag 600NB1A and remove the main shaft bearing blocks. You will need to get more of the flat head allen bolts for all of the things we will attach to the frame plate. They are in bag 600NB1C.

Notice the letters on the sides of the bearing blocks. Two are the letter 'A' and one is 'B'. The 'B' is the bottom bearing block.

Install the bearing blocks in the positions shown, again the two 'A's are top and middle and the 'B' is the bottom. Note that the raise portion with the letter will fit in a slot in the frame and the letter should be orientented up.

Go to Page 2