 |
T-Rex
600N (belt version) |
|
T-Rex
600N (belt version) |
Page 10c[click here for index]
When putting the right frame plate on start with the bolt through
the rubber canopy support. Align the left frame plate so all of
the bearing blocks have the raised portion with the letters 'A'
and 'B' in the slots. With the frame plates sitting on a flat
surface slide the main shaft through the 'A' and 'B' bearing
blocks. This will help ensure everything is aligned. Start adding
the eight button head bolts into the bearing blocks. If the main
shaft does not turn freely then loosen the bearing blocks and
spin the main shaft a few turns then tighten them again.
Note: in the picture below you do not see the main shaft but you
should have the main shaft inserted at the time you tighten the
bolts to ensure they are aligned.
Make sure the frameset does still sit flat on the surface and
take one bolt out at a time, apply loctite and reinstall. There
are eight bolts in the bearing blocks and one inside the rubber
canopy spacer. Do both sides.
Go to Page 2